Philips IntelliVue CL SpO2 - Enabling Automatic Mode and Setting Repetition Time; Enabling Sequence Mode and Setting up the Sequence; Starting and Stopping Measurements

4 Monitoring NBP
43
Starting and Stopping Measurements
Use the setup menu or SmartKeys to start and stop measurements.
CAUTION
Use clinical judgment to decide whether to perform repeated series of STAT measurements because of
the risk of purpura, ischemia and neuropathy in the limb with the cuff.
Enabling Automatic Mode and Setting Repetition
Time
1 In the NBP menu, select Mode and select Auto from the pop-up menu.
2 For an automatic measurement, select Repeat and set the time interval between two
measurements.
Enabling Sequence Mode and Setting Up The
Sequence
1 In the NBP menu, select Mode and select Sequence from the pop-up menu.
Action to be Performed NBP Setup menu SmartKeys
Start manual measurement
Start Auto series
Start/Stop
Start/Stop
Start STAT measurement
Start NBP Stat
Start NBP STAT
Stop Manual measurements
Start/Stop
Start/Stop
Stop current Auto measurement
Start/Stop
Start/Stop
Stop current STAT measurement and end
STAT mode
Start/Stop
Start/Stop
Stop Auto, Manual or STAT measurement,
end STAT mode AND Auto/Sequence
series
Stop All
Stop All