6
6-1
2Installing PageWriter TC 70 Software
A software installation procedure takes approximately fifteen minutes to complete.
This chapter provides the following information:
Software Upgrades. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-1
Obtaining Software . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6-1
Downloading Software Files from Philips InCenter . . . . . . . . .6-1
Installing the Software Upgrade . . . . . . . . . . . . . . . . . . . . . . . . . . .6-3
Verifying the Software Installation . . . . . . . . . . . . . . . . . . . . . . . . .6-6
Software Upgrades
The upgrade path for a specific cardiograph is dependent upon the software version that is
currently installed on the unit. Follow the same procedure to upgrade the software in an
existing working unit or to install software on a new system.
Obtaining Software
The software installation procedure requires the use of
a computer with a USB slot
internet access
blank USB memory stick
The following procedure describes how to download the cardiograph software files to the
USB memory stick. If the USB memory stick with the applicable software is available,
proceed to page 6-3.
Downloading Software Files from Philips InCenter
All software upgrade files may be downloaded from the Philips InCenter web site found at:
www.incenter.medical.philips.com. The InCenter site requires an active login and password.
Instructions for obtaining a login and password are located on the right side of the main
InCenter home page.
To load the software upgrade files to the USB memory stick:
1
Insert the USB memory stick into a compatible slot on a computer or other device.
2 Go to the InCenter site (incenter.medical.philips.com) and enter your login information.
To Next Page
Loading...