Using the Barcode Reader Introduction
PageWriter TC 70 Cardiograph Service Manual 1-27
Using the Barcode Reader
The barcode reader is an optional accessory that is used to quickly enter ID information by
scanning a barcode.
The barcode reader attaches to the barcode reader connector ( ) on the rear panel of the
cardiograph. Attach the barcode reader to the cardiograph before turning on AC power.
Figure 1-8 The Barcode Reader
Using the Keyboard Shortcuts
The following key stroke combinations can be used from any cardiograph screen.
Table 1-2 Keyboard Shortcuts
Keyboard Shortcut Action
Ctrl
+ Alt + C Runs the Touch Screen Calibration test. See “Touch Screen
Calibration and Test” on page 3-41 for more information.
Ctrl + Alt + P Saves the current cardiograph screen to a USB memory stick.
To Next Page
Loading...