Philips Screeneo HDP2510 - Page 26

26 Philips · HDP2510
Wall colour correction 
Colour correction of the projected image to
adjust to coloured projection surface.
Advanced colour settings

Adjust detailed colour corrections.
Colour temperature – set to Warm to
enhance hotter colours such as red, set to
Cool to make picture bluish or set to Natural.
Dynamic contrast – adjusts the contrast to
keep it at the best level according to the
brightness of the screen.
Gamma – adjusts the gamma correction
according to the type of the projected
image: Gamma 2P2/2P4/2P4, Linear,
Enhanced, MaxBright, Enphoto, Photo,
Gamma 1,2,3.
Black level – set the black and white level to
Full range (RGB), Limit range (YCbCr and
RGB) or to Auto.
Manual White Point – manually adjusts the
white point calibration according to your
needs: Colour, Offset, Gain.
Manual colours RGB CMY – manually
adjusts colours in RGB CMY mode according
to your needs: Colour, Hue, Saturation,
Brightness.
3D settings
OK
Source
Image
3D
Sound
System
Information
2D/3D
L/R Swap
2D
O
3D settings
3D 
Sets the picture modes with 2D/3D options.
L/R Swap
Changes the screen display.
Sound settings
OK
Source
Image
3D
Sound
System
Information
Volume
Deep bass
Wide sound
Equalizer
Speaker
6
On
On
Normal
On
Sound settings
Volume 
Adjusts the volume: 0 – 20.
Deep bass 
Switches the deep bass On and Off.
Wide sound 
Switches the wide sound On and Off.
Equalizer 
Selects the equalizer mode:
Normal, Pop, Rock, Jazz, Classic, Voice.
Speaker

Switches the speaker On and Off
System settings
OK
Source
Image
3D
Sound
System
Information
Key stone
Projection mode
Sleep mode
Screen saver
Auto power down
Reset lamp timer
Language/language
Shop mode
Firmware update
0
Front
O
1 min
On
English
O
O
System settings
Keystone 
Minimizes the Keystone effect (trapezför-
mige Verzerrung des Bildes bei der Aufwärt-
sprojektion) (-32 – +32).
Projection mode

Adjusts the projection mode.
Front – normal projection; the device is
located in front of the projection surface/
screen.
Rear – rear projection; the device is located
behind the projection surface; the image is
reflected horizontally.