The default setting is depending on the
choice of Shop mode or Home mode
(see Initial installation, page 14).
Do not reset the lamp timer if the lamp
has not been replaced as this could
cause damage
(see Resetting the lamp
timer, page 30).
Settings 27
Front Ceiling – the device is hanging from
the ceiling in an upside-down position; the
image is rotated by 180 degrees.
Rear ceiling – the device is located behind
the projection surface, hanging from the ceil-
ing in an upside-down position; the image is
rotated by 180 degrees and reflected hori-
zontally.
Sleep mode
Adjusts the time until the projector should go
into sleep mode and powers off after ten
seconds if user doesn’t stop it. The follow-
ings options are available: Off, 30 min.,
45 min., 60 min., 120 min.
Screen saver
Adjusts the time until the system should
power down the lamp if no source is con-
nected to system. The followings options are
available: Off, 1 min. 2 min., 5 min., 10 min.,
30 min.
Auto power down (APD)
Switches the auto power down On and Off.
When the function is switched on, the pro-
jector should go into off mode after three
hours.
If a video is displayed, the APD should take
place three hours after last user action,
meaning that a pop-up will appear after 2:58
for two minutes, indicating that the device
will go into off mode.
Reset lamp timer
Resets the lamp timer of the system.
Language/language
Selects the desired language.
Shop Mode
Switches the shop mode On and Off.
In this mode, Screeneo is continuously dis-
played on the screen and system powers on
after power is available. System is set to shop
mode conditions and settings are set back to
default settings after a certain period of time.
Firmware update
Updates firmware (see Update firmware
with USB storage medium, page 19).
Information
OK
Source
Image
3D
Sound
System
Information
Source
Smart settings
3D settings
Equivalent lamp hour
Resolution
Firmware version
Engine version
MCU version
Model
HDMI1
Standard
2D
0 h
1920 x 1080
V1.0
V1.111
V1.11111
HDP2510
System settings
Information
Displays an overview of the status and ver-
sion of the device.
Reset functions
You can select between two different reset
functions:
Reset image settings
This function is resetting the current chosen
Smart settings back
to default mode.
Reset current image settings
Source
Image
3D
Sound
System
Information
Smart settings
Format
Brightness
Contrast
Saturation
Sharpness
Lamp power mode
Flow motion
Wall colour correction
Advanced colour settings
Standard
Original
50
50
50
16
Standard
On
OFF
Image settings
1 Press the OPTION button and use / to
select Image.
2 Confirm with OK.
3 Us
e / to select Smart settings.
4 I
n the status bar appears Reset current
image settings.
5 Us
e À/Á to select Standard*.
6 Confirm with
the RED button.
Notice
CAUTION!
To Next Page
Loading...
