32 Philips · HDP2510
The device turns itself off • When the device is running for a long period
of time, the surface becomes hot and a warn
-
ing symbol appears on the projection (see
Initial operation, page 11). The device auto-
matically turns off when it gets too hot. After
the device has cooled down, you can con-
tinue playback.
• Check that the power cable is connected cor-
rectly.
• Check the sleep mode status in the setting
menu. When the sleep mode is activated, the
device turn off after the programmed dura-
tion.
Bad image or colour quality when connecting
with HDMI
• Use the supplied HDMI cable. Third-party
cables may cause signal distortions.
The device cannot read the USB stick • The device does not support the exFAT file
system.
• Format the USB key in FAT format, then use it.
The projector does not react to remote control
commands
• Check the batteries of the remote control.
Problems Solutions
To Next Page
Loading...
