Philips Screeneo HDP2510 - Page 34

34 Philips · HDP2510
The CE marking certifies that the product meets
the main requirements of the European Parlia-
ment and Council directives
1999/5/CE, 2006/
95/CE, 2004/108/CE and 2009/125/CE on
information technology equipment, regarding
safety and health of users and regarding elec-
tromagnetic interference.
The declaration of complian
ce can be con-
sulted on the site www.screeneo
.philips.com.
Preservation of the environment as part of a
s
ustainable development plan is an essential
concern of X-GEM SAS. The desire of X-GEM
SAS is to operate systems observing the envi-
ronment. The desire of X-GEM SAS is to oper-
ate systems observing the environment and
cons
equently it has decided to integrate envi-
ronmental performances in the life cycle of this
prod
ucts, from manufacturing to commission-
ing use and elimination.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1 Thi
s device may not cause harmful
interference, and
2 Thi
s device must accept any interference
received, including interference that may
cause undesired operation.
Notice: Th
is device has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasona-
ble protection against harmful interference in a
re
sidential installation. This device generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful inter-
ference to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation. If
this device does cause harmful interference to
radio or television reception, which can be
determined by turning the device off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
device and receiver.
• Conn
ect the device into an outlet on a cir-
cuit different from that to which the
receiver is conn
ected.
• C
onsult the dealer or an experienced
radio/TV technician for help.
Caution:
Any changes or modifications not
expressly approved by the party responsible
for compliance could void the user's authority
to operate this device.
RF Exposure: A di
stance of 20 centimetres shall
be maintained between the antenna and users,
and the transmitter may not be co-located with
any other transmitter or antenna.
Canada Regulatory Compliance: Th
is device
complies with RSS-210 of the Industry Canada
Rules. Operation is subject to the following two
conditions:
1 Th
is device may not cause interference and
2 This
device must accept any interference,
including interference that may cause unde-
sired operation of the device.
IC Radiation Exposure Statement: Th
is device
complies with IC radiation exposure limits set
forth for an uncontrolled environment.
Avis d’Industrie Canada:
Cet appareil est conforme à la norme CNR-210
d
es règlements d’Industrie Canada. Son fonc-
tionnement est sujet aux deux conditions sui-
vantes:
1) Cet appareil ne doit pas provoquer d’interfé-
rences et
2) Cet appareil doit accept
er toutes les interfé-
rences, y compris celles pouvant entraîner son
dy
sfonctionnement.
Avis d’Industrie Canada sur l’exposition aux
Rayo
nnements: Cet appareil est conforme aux
li
mites d’exposition aux rayonnements d’Indus-
trie Canada pour un environnement non
con
trôlé.