76
5277A
093A The controller board could not process the Set_Value_Request
(0750
hex
) service as a wrong value was entered for the
Variable_Count parameter.
Check the call of this service.
093B The controller board could not process the service called last as the
variable length encoded in the Variable_ID paramter is not identical
with the length of the specified variable.
Check the call of the service called last.
093C The Signal_Handle object was defined incorrectly.
093D An invalid bit number was entered.
093E The maximum permissible number of Write parameters was exceeded.
093F Write parameter addresses were entered for a resident action.
0940 The controller board could not process the boot sequence without
errors due to an error in the service call.
Check the call of the service given in the
Add_Error_Info parameter.
0941 The controller board could not process the Clear_RAM_Card_Request(0159
hex
) service without errors, as a wrong
address field was specified via the parameters Resi_Length and Diag_Length.
0942 The controller board could not process the Clear_RAM_Card_
Request (0159
hex
) service, as a wrong value was entered for the
Area_Flag parameter.
Check the call of this service.
Display Description Remedy
To Next Page
Loading...
Need help?
General
