77
5277A
0943 The controller board could not process the Clear_RAM_Card_
Request (0159
hex
) service, as a wrong value was entered for the
Action_Flag parameter.
Check the call of this service.
0944 The controller board could not process the Clear_RAM_Card_
Request (0159
hex
) service, as a non-defined service flag was spec-
ified.
Check the call of this service.
0945 The controller board could not process the Clear_RAM_Card_
Request (0159
hex
) service. The access to the parameterization
memory was rejected, as the memory was not or not properly in-
serted.
Check whether the parameterization memory
was properly inserted.
0946 The access to the parameterization memory was rejected, as the
parameterization memory is write-protected.
Disable the write protection and try again.
0947 Incorrect definition of an action object. Check the definitions of the action objects.
0948 Incorrect definition of a signal object. Check the definitions of the signal objects.
0949 Incorrect definition of an event object. Check the definitions of the event objects.
0950 The controller board cannot print the information, as the RS232 in-
terface is not in the print mode.
Switch the RS232 interface into the print mode
with Set_Value_Request (0750
hex
).
Display Description Remedy
To Next Page
Loading...
