78
5277A
0951 The controller board cannot print the information, as the buffer of
the RS232 parameterization interface is full.
Wait a moment, then try again.
0952 A non-defined value was used for the Variable_ID parameter. Check the definitions of the event objects.
0953 The controller board could not process the service called last, as an
invalid parameter was specified.
Check the call of this service.
0954 The controller board could not process the service called last, as a
wrong value was specified for the Parameter_Count parameter.
Check the call of this service. The Parame-
ter_Count parameter must correspond to the
number of subsequent words.
0955 A message was not read out or sent, as the maximum permissible
mailbox size was exceeded.
If the error code occurs after a request, the mes-
sage can be read out in several steps.
0A02 The controller board could not process the service called last. A
service was sent which was not permitted in the current state.
Set the controller board to the required state
before calling the desired service.
0A03 Not enough free memory space on the controller board. Carry out a warm start of the controller board
with the Reset_Controllerboard_Request
(0956
hex
) service.
0A04 The controller board could not process the service called last. Check the call of this service.
0A05 The controller board could not process the service called last. In-
valid parameter.
Check the call of this service.
Display Description Remedy
To Next Page
Loading...
Need help?
General
