81
5277A
0A21 Logical device number was assigned more than once. Check the logical INTERBUS device number in
the configuration frame.
0A22 Inconsistent logical INTERBUS device numbers were assigned. Check the INTERBUS device numbers in the
configuration frame.
0A23 Inconsistent device levels were specified. Check the configuration frame.
0A25 The controller board did not accept the group definition. Different
group numbers were assigned for devices of one bus segment.
Assign always the same group number to all
devices of one bus segment.
0A26 The controller board did not accept the definition of an alternative group, as the assigned group number is invalid.
0A27 The controller board did not accept the definition of an alternative group, as the first device in the alternative group is
not a bus terminal module (BK).
0A28 When attempting to activate alternative groups at the same time, the controller board could not activate the specified
groups.
0A29 There was a conflict of mutual group dependencies when devices were switched on or off.
0A2A Conflict of devices due to inconsistent switching with the Control_Active_Configuration_Request (0713
hex
) service.
0A2C The specified INTERBUS device number does not exist.
0A2D Too many PCP devices are connected or more PCP devices are
specified than permitted.
Reduce the number of connected or parameter-
ized PCP devices (max. 63).
Display Description Remedy
To Next Page
Loading...
Need help?
General
