Phoenix Contact IBS ABB DSC-T - Page 95

87
5277A
0B80 The controller board cannot process the Set_Value_Request
(0750
hex
) service, as an invalid value was entered for the
Variable_ID parameter.
Use only the values specified in the description
of the Set_Value_Request (0750
hex
) service.
0B81 The controller board cannot process the Set_Value_Request
(0750
hex
) service, as the permissible value range was exceeded
when entering a parameter.
0B83 The controller board cannot process the Control_Device_
Function_Request (0714
hex
) service, as an invalid value was
entered for the Device_Function parameter.
Use only the values specified in the description
of the Control_Device_Function_Request
(0714
hex
) service.
0B84 The controller board cannot process the Control_Device_
Function_Request (0714
hex
) service, as an error occurred in the
list of physical device locations.
Please contact Phoenix Contact.
0B85 The configuration cannot be created. Please contact Phoenix Contact.
0B86 The controller board cannot process the Control_Device_
Function_Request (0714
hex
) service.
The INTERBUS device called does not have a
command register.
0B87 The controller board cannot process the Control_Device_Function_Request (0714
hex
) service, as a number was
entered for the Entry_Count parameter which is greater than the actual number.
Display Description Remedy