Photron FASTCAM Mini GigabitEthernet Interface User Manual

4.1.1. Connecting the System and a PC
Connect the LAN cable to the system as shown below.
Insert the LAN cable into the "GIGABIT ETHER1" or “GIGABIT ETHER2” connector.
•
It is NOT supported to connect and operate one camera synchronously using two PCs via the
“GIGABIT ETHER1” connector and ”GIGABIT ETHER2” connector respectively.
4.1.2. Setting the IP Address
The IP address can be specified using a remote controller (option) or using the PFV software.
•
When connecting the system to a PC or when connecting other Gigabit Ethernet interface
compatible Photron cameras, set each of those devices to a different IP address. Also, when
connecting the system to an existing network, do not use IP addresses that are already in use on
the network.
•
For the procedure for setting the IP address of the system, refer to the "Photron FASTCAM Viewer
User's Manual" or the "Remote Controller User's Manual".
75 FASTCAM SA-Z Hardware Manual

Photron FASTCAM Mini GigabitEthernet Interface Specifications

General

Brand	Photron
Model	FASTCAM Mini GigabitEthernet Interface
Category	Digital Camera
Language	English