Chapter. 4 Connecting a PC
4.1.3. Using DHCP (Dynamic Host Configuration Protocol)
The system is compatible with DHCP. In an environment where DHCP is used, the system's IP
address can be acquired from the DHCP server.
•
For details, refer to the "Photron FASTCAM Viewer User's Manual".
4.1.4. Connecting Multiple Systems and a PC
With PFV, the system’s control software, one PC can connect to and control multiple FASTCAM
series camera systems.
•
When connecting to multiple systems, set the IP address of each one to a unique setting.
4.1.5. High-speed Download Feature
The system has two sets of Gigabit Ethernet interface connectors incorporated. Using these two
connectors simultaneously will make much faster download of image data possible.
1. Conduct settings for connecting both Gigabit Ethernet 1 and Gigabit Ethernet 2 on the PC
being used.
2. On the PFV, make connection settings for one of the two connectors.
3. Connect between the PC and both connectors with LAN cables.
4. The PFV recognizes the two connectors as one single camera.
Download is made through the two LAN cables in high-speed download setting.
•
For connection to the PC, please refer to the explanation given in “GigabitEthernet Interface
Connection Manual”
•
When connecting, please be careful not to duplicate the IP address of Gigabit Ethernet connectors.
•
Depending on the capability of the PC being used, there may be a chance that the effect of
High-Speed Download function is only marginal.
76
To Next Page
Loading...
Need help?
General
