<3> or Intensity Control Channel 2 <4>), until the muscle contraction is sufficient. The therapy
time elapses.
CAUTION
Make sure you do not touch the electrodes when the current is turned up!
When using the manual release key, release a pulse each time you turn up the intensity!
During a pulse pause only turn the intensity slightly to avoid unpleasant muscle reac-
tions.
(11) Signs of fatigue should make you stop the treatment (they may already occur after a few muscle con-
tractions)!
(12) After expiry of the timer, an acoustic signal will be issued. The intensity is turned down to zero auto-
matically. Remove the electrodes.
NOTICE
If the intensity (Intensity Control Channel I <3> or Intensity Control Channel II <4>)
is turned up during the time of release, a corresponding message will appear in the
lower status bar. Slowly turn down the intensity of the respective channel then. The
message disappears as soon as the previously set value is reached again.
The intensity can only be turned up effectively when the manual release key is de-
pressed.
5.6 Therapy with Medium Frequency Current Modes
5.6.1 Treatment with IFM Current
Current Mode IFM
You find a detailed overview about the selectable parameters under (IFM) Modulated Interference Current
on page 33.
5 Therapy with Stimulation Current PHYSIOMED ELEKTROMEDIZIN AG
50 IONOSON-Basic
To Next Page
Loading...
