You find a detailed overview about the parameters adjustable under (AMF) Amplitude-Modulated Medi-
um-Frequency Current on page 34.
NOTICE
This current mode can only be applied in channel I. You cannot set a second current mode in
channel II.
How to Perform a Therapy with AMF Current
(1) Switch on the instrument.
(2) Attach the electrodes to the respective stimulation points.
(3) In the Display <1>, select the current mode AMF.
(4) Depending on the indication, select a frequency band or a fixed frequency.
(5) Set the frequency cycle F
cycl
.
(6) If necessary, alter the basic frequency F
bas
.
(7) Set the therapy time.
(8) If necessary, plug in the manual release key as therapy pause button in the Manual Release Key
Socket <11> on the front of the instrument and hand the manual release key to the patient.
(9) Slowly turn up the intensity of channel I with the Intensity Control Channel I <3>. The therapy
time elapses.
CAUTION
Make sure you do not touch the electrodes when the current is turned up!
(10) After expiry of the timer, an acoustic signal will be issued. The intensity is turned down to zero auto-
matically. Remove the electrodes.
5.6.3 Muscle Stimulation with Medium Frequency Stimulation Currents
The current mode designated for treatment with medium frequency stimulation current is KOTS (Russian
Technique). This current mode is usually applied in case of faradic excitable nervo-muscular systems. You
find a detailed overview about the parameters adjustable under Parameters for Current Mode KOTS on
page 36.
Current Mode KOTS
5 Therapy with Stimulation Current PHYSIOMED ELEKTROMEDIZIN AG
52 IONOSON-Basic
To Next Page
Loading...
