Piazzetta P950 - ENABLE BEEP (AUDIO SIGNAL); STATE STOVE; Display stove status

English
35
ENABLE BEEP (AUDIO SIGNAL)
T
his function allows you to engage or disengage the alarm signal emitted by the stove to indicate that it has received the remote
control's commands.
F
unction
A
ction
D
isplay
Select enable beep
menu
Press the MENU key. Using the SELECT MENU
k
ey select the ENABLE BEEP menu and confirm
by pressing the SET key.
M
ENU
SET
E
SC
OPT
Select enable or
disable beep.
Press the SELECT MENU key and select oN to
enable the buzzer or oFF to disable it. Confirm by
pressing the SET key. After confirmation the
readout BUZZER ENABLES will appear on the
display while the initial display will automatically
reappear on the remote control.
M
ENU
SET
ESC
O
PT
ENABLE
BEEP
!
MODE
BEEP
!
ON
D
T2040065-01
STATE STOVE
This function displays the stove status under the various operating conditions.
Function Action Display
Select stove status
menu
Press the MENU key, then using the SELECT
MENU key select the stove status STATE
STOVE menu. Confirm by pressing the SET key.
M
ENU
SET
ESC
O
PT
Display stove status
The first line displays the operating conditions, the
second line for how long the pellets have been
loading and the third line the smoke and room
temperatures detected by the sensors. A list of the
readouts which can appear in the first line is given
below:
PUL Clean grate
ALF Pressure switch activated
ALC
Safety thermostat activated
No Conn Smoke sensor disconnected
No Acc Failed ignition
Mass temp Smoke alarm activated - maximum
temperature reached
STATE
STOVE
!
PUL
02.4co
!
095 26
.
c
.
c
DT2040071-01