English
43
7
.4 Cleaning the smoke chamber - Fig. 67 / 69
Every year clean the smoke chamber as follows:
• Remove the screw that fastens the smoke chamber cover, lift the
cover slightly and remove by pulling it outwards (fig. 67 – 68).
• Use a vacuum cleaner to clean any ash and carbonous deposits
which can accumulate in the chamber, paying particular attention
not to damage the blades of the fan (fig 69).
• Check the hole inside the smoke chamber on the left, leading to
the device for measuring the vacuum, for dust and ash and clean
if necessary.
• After cleaning the chamber thoroughly refit the cover and if
necessary replace the gasket.
7.5 Cleaning the flue system
In order to get the most from your product we recommend that this
maintenance be carried out on a monthly basis.
Remove the plug from the Tee and clean the pipes.
If necessary, particularly on the first few occasions, we recommend
calling in a qualified technician.
7.6 Cleaning the ceramic cladding
The ceramic cladding must first be cleaned with a soft dry cloth before
using any detergent (even mild detergent).
Products are available on the market which are suitable for cleaning
ceramics as well as concentrated products for cleaning porcelain.
These will remove oil, ink, coffee and wine stains, etc.
NEVER SOAK THE CERAMIC CLADDING OR CLEAN IT WITH COLD
WATER WHEN IT IS STILL HOT AS THE THERMAL SHOCK COULD
CAUSE IT TO CRACK.
7.7 Cleaning the enamelled metal parts
When cleaning the enamelled metal parts of the product use a soft cloth
moistened with water.
NEVER CLEAN METALLIC PARTS USING ALCOHOL, SOLVENTS,
PETROLEUM-BASED PRODUCTS, ACETONES OR OTHER
DEGREASING OR ABRASIVE SUBSTANCES.
In the event of such substances being used the manufacturer will not
be responsible for any damage caused.
Discolouration of metallic parts may be the result of misuse.
DT2030185-01
F
ig. 67
DT2030186-01
Fig. 68
To Next Page
Loading...
