Pinnacle Systems, Inc. TARGA 3000 Cookbook

TARGA 3000 Configuration Cookbook
11/25/2002 15
3.15 Required BIOS Changes for IBM Intellistation:
MPro model 6889-xxU
MPro model 6868-xxU
ZPro model 6866-xxU
Scope: This document outlines the required changes to system BIOS to allow TARGA 3000 rev. 1.X to
operate properly. If necessary, consult IBM Intellistation system documentation for more information.
1. Boot system. At the IBM logo screen, press [F1] to enter setup. If the system boots to NT, shutdown
and power cycle to repeat. This option cannot be reached by restarting via software or the operating
system. Use right or left cursor keys to change settings.
2. Select "Devices and I/O ports".
Select "SCSI setup".
Set to "enabled".
Press [Esc]. Press [Esc].
3. Select "Start options".
Select "Startup sequence".
Set first startup device to "diskette drive 0".
Set second startup device to "CD-ROM".
Set third startup device to "hard disk 0".
Set fourth startup device to "disabled".
Set automatic power on startup sequence to "disabled".
Set error startup sequence to "disabled".
Press [Esc]. Press [Esc].
4. Select " Advanced Setup".
Select “PCI Control".
Set PCI Parity to "Disabled".
Press [ESC]. Press [ESC]
5. Select "Power management".
Select "APM".
Set APM BIOS mode to "disabled".
Set Automatic hardware power management to disabled.
Press [Esc].
6. Select "Automatic power on".
Select "Wake on LAN".
Set Wake on LAN to "disabled".
Press [Esc].
7. Set Serial Port A ring detect to "disabled".
Set Modem ring detect to "disabled".
Set Wake up on alarm to "disabled".
Set PCI wake up to "disabled".
Press [Esc]. Press [Esc].
Changes are now complete. Exit and restart system.

Pinnacle Systems, Inc. TARGA 3000 Specifications

General

Brand	Pinnacle Systems, Inc.
Model	TARGA 3000
Category	Computer Hardware
Language	English