TARGA 3000 Configuration Cookbook
11/25/2002
39
4.13 IWILL DX400-SN
IWILL DX400-SN
DX400 Homepage
PERFORMANCE RATING:
3 Uncompressed YUV streams
TESTED CONFIGURATION:
2 x 1.7GHz Intel Pentium Xeon Processors
2 x 256MB PC800 ECC RDRAM from
Apacer
1 x ATI RAGE 128GL 32MB AGP
1 x Adaptec AHA-39160 Dual Channel U160
1 x Seagate ST31803LW System Drive
8 x Seagate ST318452LC in JBOD Chassis
Windows 2000 SP2, DirectX8.0a
Adobe Premiere 6.01
Targa 3000 version 1.5
SLOT ASSIGNMENTS:
AGP: ATI RAGE 128 GL AGP
PCI32-2: Empty
PCI32-1: Empty
PCI64-2: TARGA 3000
PCI64-1: AHA-39160
CONFIGURATION NOTES:
Mainboard requires P4 compatible power
supply 400W or higher in order to operate
properly.
Memory Expansion Card might require
specially designed chassis that supports 7
full length cards.
Iwill recommended NMB IT002A430WSW
power supply to be used.
Under Windows 2000, Intel INF installer
version 3.20 or higher needed.
For optimum IDE transfer, use Intel’s
UltraATA driver version 6.20 or higher.
FEATURES AND SPECIFICATIONS:
Form Factor:
ATX form factor with 305mm x 330mm board size
Supported Processors:
Supports dual/single Intel® XeonTM(Socket 603) processor
Supports CPU speed from 1.3GHz up to 1.7GHz and higher
Memory Type:
Supports DRDRAM modules (RAMBUS memory)
Bus operating at a clock rate of 400MHz to 800MHz Max 4GB
memory capacity
Chipset:
Intel® 860 chipset
MCH(1012 OLGA)-memory & graphic
ICH2(36 0EBGA)-I/O controller
FWH(32 PLCC)-BIOS and management controller
P64H(241 mBGA)-64bit bus master PCI expander
I/O Expansion Slots:
1 x AGP Pro Slot supports AGP 4X mode
Supports AGP Pro 1.5V only
2 x 64-bit/66MHz Bus Master PCI Slots
3 x 32-bit/33MHz Bus Master PCI Slots
Integrated Devices:
Onboard dual channel ATA100 IDE controller
Onboard dual channel Ultra160 Qlogic SCSI controller
AD1881 AC’97 Audio CODEC
Integrated Intel® 82559 10/100 LAN controller
1 x Floppy connector supports up to two drives
1 x 9-pin 16550-based serial ports
1 x 25-pin SPP/ECP/EPP parallel
2 x PS/2 connectors(keyboard and mouse)
6 x USB ports (2 x internal USB)
Chassis Compatibility:
WATX compatible chassis
To Next Page
Loading...
Need help?
General
