TARGA 3000 Configuration Cookbook
11/25/2002
19
3.19 Silicon Graphics 550 Workstation
SGI Product Information
Tested Configuration
BIOS revision and date - System BIOS version 4.0,
SMBIOS 2.3 (not yet released)
OS and service pack info. - Windows NT 4.0 SP6
Processor count and speed - Dual 733MHz. Xeon
Memory type and amount - RDRAM, 256MB 2-
128RIMM modules
Display adapter - Nvidia/SGI Vpro OpenGL adapter
(NV10 64MB Quadro)
System drive subsystem - integrated dual-channel
daptec 7899 Ultra160/M LVD SCSI controller with a
Seagate ST318436LW Ulta2 LVD SCSI Barracuda
hard drive.
Video drive subsystem - Atto UL2D dual channel
Ultra2 LVD SCSI adapter with eight Quantum Atlas
10k Ultra160/m SCSI drives
BIOS settings - Default factory settings with power
management turned off
Technical Advisories
1. PCILOCK Boot Option
2. Installation notes - If the NIC is installed
and configured prior to TARGA3K
installation, the TARGA3K installation
will cause the BIOS to remap the NIC to
a different PCI bus. This remapping
causes the NIC driver to fail since it can
no longer find the adapter at the PCI
address it expects. Reinstallation of the
NIC driver software will resolve this
remapping issue.
Specification
Chipset - Intel 840
Bus frequency - 133 FSB
Form factor - ATX
Power supply - 450W
PCI/AGP slot count and type - one AGP 4X Pro, two
64bit/33MHz. PCI and three 32bit/33MHz. PCI
integrated peripherals
audio: Analog Devices AD1881 chip
I/O interface
Two 9-pin serial ports (16550 UART)
One 25-pin parallel port
Two Universal Serial Bus (USB) ports
One PS/2 mouse port
One PS/2 keyboard port
network interface - integrated Intel 82559 fast
ethernet controller
To Next Page
Loading...
Need help?
General
