Pipistrel Sinus - Page 141

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 Reuse the rubber hoses that you removed earlier with the cooling canister. Trim them so that you have
3 hoses with different lengths; 500mm, 530 mm and 380mm.
 Set up the distributor as seen in the picture below. Fit the 530mm hose to the left spout, the 500mm
hose to the right spout and the 380mm hose to the front spout. Use 12mm diameter hose clamps.
 Cut one more length of hose to 920mm.
 Now place the distributor on the motor as shown in the photos below. One hose gets fed towards the
fuel pump, one through cylinder heads 2/4 and the last under cylinder head 3.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 141 of 267