Pipistrel Sinus - Page 243

K i t M a n u a l f o r P i p i s t r e l S i n u s a n d V i r u s A i r c r a f t
 Mount the brace using the two screws and spring washers provided. Be sure to mount it
using the middle hole (3
rd
) on both sides.
 Prepare the 275 mm push rod with a rod end and washer at each end.
• Now mount it to the servomotor's arm using the three washers, nut and bolt provided.
The two thicker washers are to be placed on either side of the rod end, while the thinner
washer gets placed between the servomotor's arm and the bolt head.
http://www.pipistrel.si © Pipistrel Release March 2009 © Page 243 of 267