6. Remove the old tape core from the feeding area.
7. Tear or cut (preferred method)off the end of the new roll tape to leave a straight edge.
8. Drop the new roll tape into the well. Make sure the leading tape edge comes up from under the roll
and to the right.
9. Select Feed forward >>. The system will advance the tape feed drive.
10. Insert the lead edge of the tape into the entrance guide. The system will advance the tape to the
proper position.
11. Close the cover.
Maintenance
Pitney Bowes Operator Guide February,2018 Page 245 of 349
To Next Page
Loading...
