HybridDigitalVideoRecorder
HDVRseries
29
PTZ turned to the corresponding preset point.
Value Input Field
Picture 4.10 PTZ Control
2. Cruise between Points
Multiple preset points connects to cruise lines, call cruise between points and the PTZ runs
around on the line
1) Cruise Between Points Settings
Cruise lines are connected by multiple preset points; setting procedure is shown below.
Step1: Refer to Picture 4.8; the Direction key will turn PTZ to designate a location. Click the
Settings button to enter PTZ to configure interface as Picture 4.11 shows.
Step 2: Click the Cruise button to input proper value in the Cruise Line and Preset Points fields.
Next, click the Add Preset Points button to complete setting (also can add and delete
cruise line which has been set up).
Step 3: Repeat Steps 1 and 2 to set out all the preset designated cruise lines.
Remove Preset: Please input preset value in the field; click the Remove Preset button to
remove the preset points.
Remove Cruise Line: Input the number of cruise line, click the Remove Cruise Lines button to
remove the cruise lines set.
Preset Points
Time Interval
Cruise Button
Cruise Line Field
Picture 4.11 Cruise between Point Settings
2) The Calls of Cruise between Points
Refer to Picture 4.8; click the Page Shift button to enter PTZ control menu as shown in Picture
4.10. Please input the number of cruise in the value field and then click Cruise between the
Points button. Next, PTZ begins to work on the cruise line. You can click the Stop button to
stop cruise.
To Next Page
Loading...
Need help?
General
