HybridDigitalVideoRecorder
HDVRseries
45
Video Blind in Full Digital (NVR) Mode
Picture 5.8 Video Blind
Set method: Refer to Motion Detection in Chapter 5.3.1.
5.3.3 Video Loss
When the equipment cannot obtain the channel video signal, the video loss alarm and the
linkage function are turned on. Though the same as motion detection function, video loss is
different between hybrid mode and full digital mode. The details are shown below.
Digital channel: It not only enables video loss function at the local side, but also enables the
remote device that is connected. When remote device is with video loss, the local side will start
alarm recording, otherwise this function is not enabled.
To Next Page
Loading...
Need help?
General
