HybridDigitalVideoRecorder
HDVRseries
41
5.3.1 Motion Detection
When system detects the motion signal that reaches the set sensitivity, the motion detection
alarm is on and the linkage function is turned on. Motion detection function is different between
hybrid mode and full digital mode. The details are shown below.
Digital channel: It not only enables motion detection function at the local side, but also
enables the remote device that is connected. When remote device detects motion movement,
the local side will start alarm recording, provided this function is not enabled.
Hybrid mode: It only enables motion detection function at the local side.
Video Detection in Hybrid Mode
Video Detection in Full Digital (NVR) Mode
Picture 5.4 Motion Detection
To Next Page
Loading...
