User Manual of VDR-300NU
scanning.
Clients Isolation
When many clients connect to the same access point, they can access
each other. If you want to disable the access between the clients that
connect to the same access point, you can select this option.
Disable WMM
Advertise
After enabling this option, the transmission performance multimedia of
the voice and video data can be improved.
Enable Wireless
Multicast
Forwarding (WMF)
After enabling this option, the transmission quality of video service
such as IPTV can be improved.
SSID
For the security reason, you should change the default SSID to a
unique name.
BSSID
Display the MAC address of the wireless interface.
Country
The name of the country with which your gateway is configured. This
parameter further specifies your wireless connection. For example, the
channel will adjust according to nations to adapt to each nation's
frequency provision.
Max Clients
Specify the maximum wireless client stations to be enabled to link with
AP. Once the clients exceed the max value, all other clients are
refused. The value of maximum clients is 16.
Wireless
Guest/Virtual Access Points: If you want to make Guest/Virtual network
function be available, you have to check those boxes in the table
below. In the current software version, three virtual access points can
be configured.
After finishing setting, click Apply/Save to save the basic wireless settings and make the settings take
effect.
98
To Next Page
Loading...
