Planet XGS3-24042 - Page 199

22-36
Interface Configuration Mode
ipv6 nd prefix
<ipv6-address/prefix-length>
<valid-lifetime> <preferred-lifetime>
[off-link] [no-autoconfig]
no ipv6 nd prefix
<ipv6-address/prefix-length>
<valid-lifetime> <preferred-lifetime>
[off-link] [no-autoconfig]
Configure the address prefix and
advertisement parameters of router. The
NO command cancels the address prefix
of routing advertisement.
(8) Configure static IPv6 neighbor Entries
Command
Explanation
Interface Configuration Mode
ipv6 neighbor <ipv6-address>
<hardware-address> interface
<interface-type interface-name>
Set static neighbor table entries, including
neighbor IPv6 address, MAC address and
two-layer port.
no ipv6 neighbor <ipv6-address>
Delete neighbor table entries.
(9) Delete all entries in IPv6 neighbor table
Command
Explanation
Admin Mode
clear ipv6 neighbors
Clear all static neighbor table entries.
(10) Set the hoplimit of sending router advertisement
Command
Explanation
Interface Configuration Mode
ipv6 nd ra-hoplimit <value>
Set the hoplimit of sending router
advertisement.
(11) Set the mtu of sending router advertisement
Command
Explanation
Interface Configuration Mode
ipv6 nd ra-mtu <value>
Set the mtu of sending router
advertisement.
(12) Set the reachable-time of sending router advertisement
Command
Explanation
Interface Configuration Mode
ipv6 nd reachable-time <seconds>
Set the reachable-time of sending router
advertisement.
(13) Set the retrans-timer of sending router advertisement
Command
Explanation