Planet XGS3-24042 - Page 200

22-37
Interface Configuration Mode
ipv6 nd retrans-timer <seconds>
Set the retrans-timer of sending router
advertisement.
(14) Set the flag representing whether information other than the address information will be obtained via
DHCPv6.
Command
Explanation
Interface Configuration Mode
ipv6 nd other-config-flag
Set the flag representing whether
information other than the address
information will be obtained via DHCPv6.
(15) Set the flag representing whether the address information will be obtained via DHCPv6
Command
Explanation
Interface Configuration Mode
ipv6 nd managed-config-flag
Set the flag representing whether the
address information will be obtained via
DHCPv6.
3. IPv6 Tunnel Configuration
(1) Add/Delete tunnel
Command
Explanation
Global mode
interface tunnel <tnl-id>
no interface tunnel <tnl-id>
Create a tunnel. The NO command
deletes a tunnel.
(2) Configure tunnel description
Command
Explanation
Tunnel Configuration Mode
description <desc>
no description
Configure tunnel description. The NO
command deletes the tunnel description.
(3) Configure tunnel source
Command
Explanation
Tunnel Configuration Mode
tunnel source { <ipv4-address> |
<ipv6-address>| <interface-name> }
no tunnel source
Configure tunnel source end IPv4/IPv6
address. The NO command deletes the
IPv4/IPv6 address of tunnel source end.
(4) Configure Tunnel Destination
Command
Explanation