Planet XGS3-24042 - Page 299

37-5
4）Configure split horizon
Command
Explanation
Interface configuration mode
IPv6 rip split-horizon [poisoned]
Configure that take the split-horizon when the
port sends data packets, poisoned means with
poison reverse.
no IPv6 rip split-horizon
Cancel the split-horizon.
3. Configure other RIPng protocol parameters
(1) Configure timer for RIPng update, timeout and hold-down
Command
Explanation
Router configuration mode
timers basic <update> <invalid>
<garbage>
no timers basic
Adjust the renew, timeout and garbage recycle
RIPng timer, the no timers basic command
restore the default configuration.
4. Delete the specified route in RIPng route table
Command
Explanation
Admin Mode
clear IPv6 rip route
{<IPv6-address>|kernel|static|conn
ected|rip|ospf|isis|bgp|all}
the command deletes a specified route from the
RIP route table.
5. Configure RIPng route aggregation
(1) Configure IPv6 aggregation route globally
Command
Explanation
Router Configuration Mode
ipv6 rip aggregate-address
X:X::X:X/M
no ipv6 rip aggregate-address
X:X::X:X/M
To configure or delete IPv6 aggregation route
globally.
(2) Configure IPv6 aggregation route on interface
Command
Explanation
Interface Configuration Mode