Planmeca PlanMill 60 S - 9.6 Coolant lubricant system

9.6 Coolant lubricant system
The coolant lubricant system is optimally tailored to the milling unit in the
factory. Only use approved coolant lubricant from Planmeca, because this
is optimally tailored to the requirements of the milling unit and guarantees a
seamless processing sequence.
1 Coolant lubricant tank
2 Front panel
9.6.1 Coolant lubricant tank
The capacity of the Planmeca PlanMill 60 S milling unit’s coolant lubricant
tank is 3 litres. The tank consists of several components, see below. The
9 Planmeca 60 S milling unit
User's manual Planmeca PlanMill 60 S 31