Maintenance intervals
• Machine
Can be reset only by technichian.
• Coolant lubricant
Can be reset by user by pressing the button when the lubricant is
changed.
13.5.4 Calibration
The
Settings
>
Calibration
menu contains functions for calibrating the milling
unit.
For calibration instructions, see section "Calibrating milling unit" on page
86.
13.5.5 Functions
In the
Settings
>
Functions
menu you can perform the following actions by
pressing the toggle button:
• switch on/off the coolant lubricant pump
• switch on/off the suction
• switch on/off the cleaning air
• open/close the collet.
13 Control software
46 Planmeca PlanMill 60 S User's manual
To Next Page