POFUNG BF9500 - Basic Operations; Professional Transceiver Mode; Switching the Power On;Off; Transmitting;Receiving

BF9500 车载台使用说明书
1）Frequency+Channel mode：When set display as"FR",it enters into Frequency+Channel mode, new setting of channel
operation and shortcut operation can be temporarily used by user. Once the radio is turned off or switched to another channel,
the temporary setting will be erased and back to initial settings.
2） Channel+Name Tag Mode：When set display as "NM",it enters into Channel +Name Tag mode. At this mode, it will display
corresponding channel name when the current channel is edited with name. Otherwise, it will display frequency + channel. Its operations
are the same as frequency + channel mode.
3） VFO Mode（Frequency mode）：This mode shows only frequency on the display. Shortcut operation and Channel setting will be
changed & stored as the latest value permanently.Once the radio is turned off or changed to new VFO frequency, the latest setting is
remained until next change.
3. Professional Transceiver Mode 专业机模式
When set display mode as "CH",it enters into Professional Transceiver mode.At this mode,except scan,other shortcut operation
can't operate.And from No.1-15 menu in function setting will be auto-hidden,They should be set by PC software.If there is
corresponding name for current channel,the LCD will display current channel name Otherwise,it shows current channel number.
■ Basic Operations 基本操作
1. Switching The Power On/Off 车载台开启与关闭
1） Press the key to open the radio power.( Light is light orange)
2） Press the key for 1s to turn off.
2. Adjusting The Volume 调节音量
1）Turn the VOL knob clockwise to increase the audio level.
2）counterclockwise to decrease the audio level.
3. Transmitting （发射）
1）Please hold the Microphone, Then press and hold [PTT] key to speak into microphone.
·Please hold the microphone approximately 5.0cm from your lips, and then speak into the microphone in your normal
speaking voice to get best timbre.
·Press and hold [PTT] key, TX light and a red glow.
·If use outside launch coverage area, walkie-talkie fault of a loud sound.
2.）Loosen the microphones [PTT] to receive。
4. Receiving 进行接收