POFUNG BF9500 - Launch; Busy Channel Lockout; Talk Around

BF9500 车载台使用说明书
6. Setup process short press , then cancel save , and switch to the on a menu or next a menu；
7. Press to other keys , cancel the save and return to main interface.
7. Launch 发射允许
1) In standby mode, press and hold key to enter general setting menu；
2) Adjust the knob switch or Mic's key, and select 07 menu option, the screen display
3) Short press the key, enter the function menu, the screen flashing "OFF", Options are "OFF/ON"；
4) Adjust the knob switch or Mic's key choose to OFF；
5) Short press the key, save and exit the Settings；
6) Setup process short press , then cancel save , and switch to the on a menu or next a menu；
7) Press to other keys , cancel the save and return to main interface.
Set to TX. OFF, press (PTT) function is invalid, launch is prohibited.
8.Busy Channel Lockout 繁忙禁发
BCLO is to disable transmitting while RX signal is received. Once the channel is busy and you press PTT, the radio will beep as
warning and get back to receiving.
1）In standby mode, press and hold key to enter general setting menu；
2）Adjust the knob switch or Mic's key, and select 08 menu option, the screen display ；
3）Short press the key, enter the function menu, the screen flashing "OFF", Options are "OFF/ON"；
4）Adjust the knob switch or Mic's key choose to ON；
5）Short press the key, save and exit the Settings；
6） Setup process short press , then cancel save , and switch to the on a menu or next a menu；
7）Press to other keys , cancel the save and return to main interface.
9.Talk Around 脱网功能
△This function effective if used with relay point.
By Talk Around function,you can directly communicate with other radios in your group in case the repeater is not activated or
when you are out of the repeater range. The transceiver will transmit by RX frequency with its CTCSS/DCS signaling.
1）In standby mode, press and hold key to enter general setting menu；
2）Adjust the knob switch or Mic's key, and select 09 menu option, the screen display ；
3）Short press the key, enter the function menu, the screen flashing "OF", Options are "OF/ON"；