BF9500 车载台使用说明书
■Mobile installation
To install the transceiver, select a safe, convenient location inside your vehicle that minimizes danger to your passengers and
yourself while the vehicle is in motion. Consider installing the unit at an appropriate position so that knees or legs will not strike it
during sudden braking of your vehicle. Try to pick a well ventilated location that is shielded from direct sunlight.
1. Install the mounting bracket in the vehicle using the supplied self-tapping screws(4pcs) and flat washers(4pcs).
2. Position the transceiver, then insert and tighten the supplied hexagon SEMS screws(4pcs) and flat washer(4pcs).
·Double check that all screws are tightened to prevent vehicle vibration from loosening the bracket or transceiver.
·Determine the appropriate angle of the transceiver, using the 3 screw hole positions on the side of the mounting bracket.
■DC Power Cable Connection
1. Mobile Radio Operation
The vehicle battery must have a nominal rating of 12V. Never connect the mobile radio to a 24V battery. Be sure to use a 12V
vehicle battery that has sufficient current capacity. If the current to the mobile radio is insufficient, the display may darken during
transmission, or transmitting output power may drop excessively.
To Next Page
Loading...