Point Grey Flea3 GigE - Page 50

Point Grey Flea3 GigE Technical Reference 7 Image Acquisition
Name Display Name Description Value
FrameRateAuto Frame Rate Auto
Controls the mode for automatic
frame rate adjustment
Off
Continuous
TriggerSelector Trigger Selector
Selects the type of trigger to
configure. Derived from Exposure
Mode.
Exposure Start/
Exposure Active
TriggerMode Trigger Mode
Controls whether or not the
selected trigger is active
Off
On
TriggerSource Trigger Source
Specifies the internal signal or
physical input line to use as the
trigger source. The selected
trigger must have its Trigger
Mode set to On.
Software
Line x where x is a
GPIOtrigger pin
TriggerActivation Trigger Activation
Specifies the activation mode of
the trigger
Falling Edge
Rising Edge
TriggerDelay TriggerDelay (us)
Specifies the delay (in
microseconds) to apply after the
trigger reception before activating
it
TriggerDelayEnabled Trigger Delay Enabled
Specifies whether or not the
Trigger Delay is enabled
True
False
ExposureMode
Exposure Mode
(not all models support all
modes)
Sets the operation mode of the
exposure (shutter). Toggles the
Trigger Selector. Timed =
Exposure Start; Trigger Width =
Exposure Active
Timed
Trigger Width
ExposureTime ExposureTime (us)
Exposure time in microseconds
when Exposure Mode is Timed
ExposureAuto Exposure Auto
Sets the automatic exposure
mode when Exposure mode is
Timed
Off
Once
Continuous
Revised 10/29/2013
Copyright ©2010-2013 Point Grey Research Inc.
40