Point Grey Flea3 GigE Technical Reference 8 Flea3 GigE Attributes
To control Bayer color processing:
n GenICam—Image Format Control
n FlyCapture API—Accessing Raw Bayer Data using FlyCapture
Accessing Raw Bayer Data
The actual physical arrangement of the red, green and blue "pixels" for a given camera is determined by the
arrangement of the color filter array on the imaging sensor itself. The format, or order, in which this raw color data is
streamed out, however, depends on the specific camera model and firmware version.
Title Article
Different color processing algorithms Knowledge Base Article 33
Writing color processing software and color interpolation
algorithms
Knowledge Base Article 37
How is color processing performed on my camera's images? Knowledge Base Article 89
Related Knowledge Base Articles
8.19 Hue
Hue is applicable to color models only.
This provides a mechanism to control the Hue component of the images being produced by the Flea3 GigE, given a
standard Hue, Saturation, Value (HSV) color space.
To adjust hue use:
n GenICam—Analog Control
n FlyCapture API—Setting Hue Using the FlyCapture API
8.20 Saturation
Saturation is applicable to color models only.
This provides a mechanism to control the Saturation component of the images being produced by the Flea3 GigE, given
a standard Hue, Saturation, Value (HSV) color space.
Saturation in this context does not refer to the saturation of a sensor charge.
To adjust saturation use:
n GenICam—Analog Control
n FlyCapture API—Setting Saturation Using the FlyCapture API
Revised 10/29/2013
Copyright ©2010-2013 Point Grey Research Inc.
81
To Next Page
Loading...
