Point Grey Flea3 GigE Technical Reference 8 Flea3 GigE Attributes
8.6 Overview of Imaging Parameters
The camera supports control over the following imaging parameters:
Imaging Parameter GenICam Feature FlyCapture API Sample Code
Brightness Analog Control Setting Brightness Using the FlyCapture API
Shutter Time Acquisition Control Setting Shutter Using the FlyCapture API
Gain Analog Control Setting Gain Using the FlyCapture API
Auto Exposure Acquisition Control Setting Auto Exposure Using the FlyCapture API
Sharpness Analog Control Setting Sharpness Using the FlyCapture API
Gamma and Lookup
Table
Analog Control Setting Gamma Using the FlyCapture API
CSRcontrol: LUT: 80000h
– 80048h
Image Flip/Mirror Image Format Control
Embedded Image
Information
CSRcontrol: FRAME_
INFO: 12F8h
White Balance (color
models only)
Analog Control Setting White Balance Using the FlyCapture API
Bayer Color Processing
(color models only)
Image Format Control Accessing Raw Bayer Data using FlyCapture
Hue (color models only) Analog Control Setting Hue Using the FlyCapture API
Saturation (color
models only)
Analog Control Setting Saturation Using the FlyCapture API
Most of these imaging parameters are defined by modes and values.
There are three modes:
Mode Description
Off Feature is in manual mode and values can be set
Continuous Feature is in automatic mode and values cannot be set
Once Feature executes once automatically and then returns to manual mode
GenICam Control
The term Continuous is the same as Auto and the term Once is the same as One Push.
Users can define the values for manual operation of a feature.
Revised 10/29/2013
Copyright ©2010-2013 Point Grey Research Inc.
70
To Next Page
Loading...
