3
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
© Copyright Polaris Industries Inc.
3.79
OIL PICKUP ASSEMBLY INSPECTION
The oil pickup assembly is located in the oil sump cover
e
.
1. Remove and discard the oil inlet seal
q
. Verify the
oil seal is not inside the pickup bore in the
crankcase.
2. Apply white lithium grease to the ID and OD of a a
new oil inlet seal. Install new oil inlet seal into the
crankcase oil pickup bore.
3. Remove the oil pickup assembly fasteners
w
from
the oil sump cover
e
.
4. Thoroughly clean the pickup assembly.
5. Inspect the oil pickup assembly for cracks and
excessive wear. Replace if necessary.
6. After cleaning and inspecting pickup assembly,
install it into the oil sump and torque screws to
specification.
TORQUE
Oil Pickup Screws:
5 ft-lbs (7 Nm)
CRANKCASE INSPECTION
1. Remove all traces of gasket sealer from the
crankcase mating surfaces. Inspect the surfaces
closely for nicks, burrs or damage.
2. Be sure alignment pins are in place where used.
3. Be sure oil passages are clean and free of any
cleaning solvent.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
Need help?
General
