7.46
FINAL DRIVE
3. Remove the differential assembly from the housing.
4. Inspect the ring gear and differential gears for chipped,
worn, or broken teeth.
5. Remove the bearing from the top portion of the differential
assembly. Inspect the bearing for smoothness and wear.
6. Remove the shim(s) from the differential assembly. Be sure
to keep the shims together for reassembly.
7. Remove the bearing from the lower portion of the
differential assembly. Inspect the bearing for smoothness
and wear.
8. Remove the shim(s) from the differential assembly. Be sure
to keep the shims together for reassembly.
Inspect Teeth
www.midwestmanuals.com www.green-manuals.com
To Next Page
Loading...
