7.37
FINAL DRIVE
7
REAR GEARCASE
Gearcase Removal
1. Drain the fluid from the rear gearcase and remove the rear
drive shafts from each side of the rear gearcase.
See “REAR DRIVE SHAFT” on page 7.29
2. Remove the exhaust pipe and exhaust silencer to allow for
gearcase removal.
3. RZR S Only: Remove the upper A-arm bolts, lower rear
A-arm bolts, and suspension plate. NOTE: If accessory
rear rack cab frame is installed, remove the (4) bolts
retaining it to the rear suspension plate (see photo).
4. Remove the (2) rear gearcase mount bracket fasteners and
mount bolt and remove bracket from vehicle.
5. Remove the fasteners and bracket that secure the rear
gearcase to the transmission.
6. Remove the (4) fasteners and remove the rear mount from
the rear gearcase.
Silencer
Remove
Remove
Remove
Remove
Suspension
Plate
Remove
Remove
www.midwestmanuals.com www.green-manuals.com
To Next Page
Loading...
