10.5
ELECTRICAL
10
Ignition Key Switch (INT’L)
1. Disconnect the key switch harness by lifting the connector
lock and pulling on the connector. Do not pull on the
wiring.
2. Test between the 4 sets of outputs (OFF / ON LIGHTS / ON
/ START). If any of the tests fail, replace ignition switch
assembly.
• Turn the ignition key to ON LIGHTS. There should be
continuity between switch pins A, E and F; C and D.
• Turn the ignition key to ON. There should be continuity
between pins C and D; E and F.
• Turn the ignition key to START. There should be
continuity between pins A and B; C and D; E and F.
AWD / 2WD Switch
1. Disconnect the AWD / 2WD switch harness by depressing
the connector locks and pulling on the connector. Do not
pull on the wiring.
2. Test between the 2 sets of outputs (AWD / 2WD). If any of
the tests fail, replace the switch assembly.
• Move the switch to AWD (ON). There should be
continuity between switch pins 2 and 3.
• Move the switch to 2WD (NONE / OFF). There should
be no continuity between any pins.
www.midwestmanuals.com www.green-manuals.com
To Next Page
Loading...
Need help?
General
