Polaris Ranger RZR 800 - Tail; Brake Lights; Bulb Replacement

10.17
ELECTRICAL
10
TAIL / BRAKE LIGHTS
Bulb Replacement
Before replacing the bulb(s), use a digital multi-meter to test the
harness to ensure the lamp is receiving 12 volts and that a ground
path is present.
If a tail light, brake light or turn signal (INT’L Only) does not
work the bulb may need to be replaced.
1. Remove bulb by turning the rubber base 1/4 turn and
pulling the bulb out. Replace it with recommended bulb.
Apply Dielectric Grease (PN 2871329).
2. Test the tail light, brake light and turn signal (INT’L Only)
to verify it is working properly.
Tail / Brake
Light
Tail / Brake
Light
Turn Signal
Light
INT’L
Models
www.midwestmanuals.com www.green-manuals.com