POLMAR Shark - Acknowledgement of an individual incoming call; Last call (recall most recent incoming); Send individual call using call log; Pos request and reply

25
5.2.4.3 Acknowledgement of an individual incoming call
1 If INDIV REPLY switches to MANUAL the radio requires the operator to ma
-
nually send an acknowledgement to the requesting radio. Press CH key to
send an acknowledgement or CANCEL key to cancel.
2 If INDIV REPLY switches to AUTOMATIC the radio will automatically send an
acknowledgement to the requesting radio within 10 seconds of receiving the
call.
5.2.5 Last call (recall the most recent incoming call)
This facility also is useful and is used frequently as routing individual call
1 Press the DSC / Menu key to enter the DSC mode LAST CALL will be pointed,
press CH key to display the detail information of the last call
2 Select the working channel for individual call and press CH key, The radio
summarizes the call details and ask for confirmation to send the call
3 press CH knob to send the call
5.2.6 Send an individual call using the call log
The CALL LOG contains the contact details for the 20 most recent incoming
calls, so you call any of them again quickly
1 Press the DSC / Menu key to enter the DSC mode, select CALL LOG,
Press up/down key to scroll for previous call.
2 Press the CH key to conform the choice then follow the as the ways to make
the call in.5.2.4.2
(To save this log entry you BUDDY LIST, select SAVE, then press ENT and
enter a name the logged MMSI is automatically displayed.)
5. 2.7 Pos request and pos reply
5. 2.7.1 Pos request (request the ll position of a buddy)
The option enables you to request GPS position information from any vessel
for which an MMSI number is known.
1 Select the POS REQUEST on the DSC Menu, press the CH key to enter the BUD-
DY list (<MANUAL> AND BUDDY list) select the one for position information.
2 The Call will be initiate and same as individual call procedures.
5.2.7.2 Pop reply
The position relay can to send your position to another radio with this feature.
Your radio must have an operating GPS receiver connected to be used to
send to the position.
POS REPLY either can manually send your position information or do it auto-
matic which depending upon on your ‘s setting.