POLMAR Shark - GPS;Time Display Settings

32
The manual entry function is just valid if and only if no GPS connected
1 select GPS/TIME then manual
1 select GPS/TIME then manual
2 enter the latitude, then the longitude, then the UTC.
3 PRESS the CH knob, when all the information is correct.
The vessel’s lat/lot with the UTC time are shown on the screen. The manual
entries are cancelled if a real GPS position is received.
GPS / TIME
>MANUAL
SETTINGS
MANUAL POS
- - 0 - -.- - - - N
- - - 0 - -.- - - - W
- - :- -UTC
DISTRESS
22 0 28.1111 N
112 0 11.001W
08: 25 UTC
6.6.2 Settings
You can also set what time and position information is display on the screen
Whether Position data is displayed
Whether the time is displayed
Whether a Time Zone Offset is used
How the time data is formatted
Whether COG/SOG data is displayed
6.6.2.1 Position display on/off
You can choose the position data displayed on the normal mode or not
1 Select GPS/TIME then SETTINGS, then POS DISPLAY
2 Select ON(on) or OFF(off)as desired, this is example, selected on and the
screen shows the vessel position.
•
•
•
•
•
>POS DISPLAY
TIME DISPLAY
TIME OFFSET
TIME FORMAT
POS DISPLAY
> ON
OFF
DISTRESS
27°34.1268 N
102°55.5587 W
356° 12.6Ks