6.8 Setup DSC
The submenu is used to set behavior of the DSC/ATIS function.
The following 5 items are available for selection.
User MMSI
Group MMSI
Indiv reply
DSC enabled
Pos reply
6.8.1 Enter your user MMSI
This is a once-only operation.
You must enter your user MMSI first then you can access the DSC functions
1 Select DSC SETUP then USER MMSI and press the CH knob. If an existing
MMSI is stored, the values appear.
2 If the MMSI is blank, a dashes line appears on screen, enter user MMSI
along the dashed line. Press the CH knob to confirm each correct entry to
move to the next digit.
If your make an error, Rotate the CH knob < appears, then press the CH knob
to backup and correct the entry.
•
•
•
•
•
INPUT MMSI
NUMBER
>- - - - - - - -
HOLD ENTER
USER MMSI
INPUT AGAIN
>- - - - - - - -
HOLD ENTER
USER MMSI
ID 500000001
>SAVE
CANCEL
3 Hold the CH knob to store your user MMSI.
4 Enter your user MMSI again as a password check, hold the CH knob to per-
manently store the your user MMSI and return to the menu.
5 You can view your stored user MMSI at anytime by selecting user MMSI in
the main menu.
6 If there is no USER MMSI stored and the radio’s DSC function is attempted,
the radio says “DSC IS NOT OPERATIONAL.” & “PLEASE ENTER MMSI” as
below.
DSC IS NOT
OPERATIONAL
PLEASE ENTER
MMSI
DSC WARNING MESSAGE
36
To Next Page
Loading...
