The SoundStructure VoIP Interface
12 - 77
voip_dhcp_boot_serv_type When voip_dhcp_boot_serv is set to custom, this
parameter specifies the type of the DHCP option in
which the plug-in card will look for the boot server.
voip_dhcp_option_60_type Specifies the format for the vendor identifying
information used with a DHCP server when DHCP
option 60 is enabled.
voip_dial_mode Selects between number dialing and SIP URL
dialing.
voip_dnd Enables or disables the Do Not Disturb mode on all
lines.
voip_eth_settings Sets or gets the Ethernet settings for the plug-in
card.
voip_eth_vlan_id Sets or gets the VLAN ID for the plug-in card. A
value of -1 corresponds to no vlan id.
voip_factory_reset Resets the plug-in card to its factory state.
voip_forward Used to forward a call.
voip_hold Places the current call on hold.
voip_join Creates a conference from two calls.
voip_line Selects a line. This is similar to pressing a line key
on a desktop phone.
voip_line_label Reports the label for the specified line.
voip_line_state Reports the state for the specified line, e.g.,
registered, not registered, active, conference, hold,
etc.
voip_local_reset Resets all the voip parameters that SoundStructure
Studio can set: ring type, auto answer, volume of
the auto answer tone.
voip_message_waiting Indicates whether voice mail messages from any
registered lines are waiting for the SoundStructure
VoIP Interface
voip_net_cfg_save Causes the VoIP network settings to be written to
the flash memory.
voip_prov_serv_address Sets the address of the provisioning server for the
VoIP interface.
voip_prov_serv_password Sets the password for the provisioning server for
the VoIP interface.
voip_prov_serv_type Sets the type of provisioning server for the plug-in
card.
voip_prov_serv_user Sets the username for logging into the provisioning
server.
To Next Page
Need help?
General
