The SoundStructure VoIP Interface
12 - 11
Creating a New Project with the SoundStructure VoIP interface
While the previous section focuses on converting an existing project, this sec-
tion focuses on creating a new project with the SoundStructure VoIP Interface.
To create a new project, follow these steps.
1. Launch SoundStructure Studio, select the File menu, and then select New
Project.
2. In Create a Project - Step 1, select the inputs to be used in this project and
after each selection click Add. The following figure shows an example
system with 8 analog microphones (Table Mics 1 through 8), a
SoundStructure VoIP interface (VoIP In), and mono program audio input
(Program Audio).
Click Next to select the outputs from the system.
To Next Page
Loading...
