13 - 1
16
Using SoundStructure Studio
Controls
The SoundStructure Studio software environment includes various user inter-
face controls for adjusting the parameters of virtual channels. This section
summarizes how to use these controls.
Adjusting Knobs
There are three ways to change the value associated with a knob control:
1. With the mouse: left click (and hold the button) and move the curser up
to increase the value and down to decrease the value. Release the mouse
when the parameter setting is at the desired value.
2. With the mouse and keyboard: left click on the knob and then use the
cursor arrows to change the value by increments of 1 and use the page up
and page down commands to move the parameter by 10 dB (or to adjust
by octaves) on frequency plots.
3. Keyboard: left click the mouse on the text field and type in a value
followed by the Enter key.
To Next Page
Loading...
Need help?
General
